Skip to main content
In Satisfactory, a Pipeline Mk.1 carries up to 300 m³ per minute and a Pipeline Mk.2 up to 600 m³ per minute. Liquids need head lift to go up, which Pipeline Pumps add (about 20 m for Mk.1, 50 m for Mk.2), but pumps do not increase the flow rate. Most pipeline “glitches” come from sloshing, too little head lift, or junctions placed onto existing pipe. These are game mechanics, so they work the same on your FREAKHOSTING server as in single player.

How do I increase pipeline throughput?

  1. Use Pipeline Mk.2. It doubles the limit to 600 m³/min. A pump doesn’t raise the limit; the pipe does.
  2. Split the flow. If you need more than 600 m³/min, run a second pipeline.
  3. Place junctions, pumps and valves first. Putting them onto an existing pipe can throttle the flow by about 1 m³/min. Place the part, then connect the pipes to it, or delete and reconnect the pipe.
  4. Avoid joining pipes of very different lengths at a junction, pump or valve.

What is head lift?

Head lift is how high a liquid can be pushed. Liquids fill the lowest pipes first, and a pipe above the available head lift never fills. Even a perfectly flat pipe needs about 1.3 m of head lift to fill completely; the pump indicator may show 1.2 to 1.5 m. When building vertical pipes, build from top to bottom; it gives a reading closer to the real height.

When do I need a Pipeline Pump?

Only when liquid has to go up higher than its source can push it. On flat runs, a pump usually does nothing useful. Pumps add head lift, not flow rate. A Mk.1 pump on a Mk.2 pipeline does not cap the flow at 300 m³/min.

Why does my pipe flow go up and down?

That is sloshing. When a side branch or dead-end of a manifold fills up, fluid flows back and the throughput drops for a while. This is normal behaviour, not a server problem. To reduce it:
  • Let the machines run only once all pipes are full and will stay full.
  • Add a loopback pipe at the end of the manifold.
Note that inserting or removing a Pipeline Junction Cross or a pump empties the fluid in that pipe, so it has to fill again.

Are pipe problems worse on a dedicated server?

No. The pipe rules are part of the game, so the numbers above are the same on a dedicated server. If pipes and belts look jumpy only on screen, that is usually network data, not the fluid itself; see belt stutter and network quality.

Frequently asked questions

Does a pump make my pipe faster?

No. Pumps add head lift so liquid can go up. The flow limit stays at 300 m³/min for Mk.1 and 600 m³/min for Mk.2.

Why is my pipe stuck below the limit?

Check for junctions or pumps placed onto existing pipe, a manifold that is sloshing, or a section higher than your head lift.

Do gases need pumps?

No. Gases need no head lift and no pumps.

My pipe still doesn’t fill. What now?

Rebuild the junction or pump first and connect the pipes afterwards, and check the head lift with the pump indicator.

Satisfactory server guide

Every Satisfactory page in one place.

Belt stutter and network quality

When items jump on screen.

Blueprints on servers

Reuse your pipe layouts.

Performance and lag

Keep a big factory running smoothly.

Checked against the official Satisfactory Wiki Pipeline and Pipeline Pump pages on 2 November 2026 for Satisfactory 1.2. Fluid behaviour may change in later game updates.

Need Extra Help?

If you encounter any issues, our support team is ready to assist:

Save on Your Hosting

Ready to upgrade your hosting? Use code KB20 at checkout for 20% off your first order!

Last Updated: November 2026